Skip to main content

By ARISE Solar Editorial Team. The team writes ARISE Solar’s guides on equipment, rooftop planning and installation.

Home rooftop solar capacity planning

Choosing a solar system size starts with your actual electricity pattern—not only with roof area or a neighbour’s system size.

Read at least a few electricity bills

Review monthly units and identify seasonal changes. This gives a better starting point than choosing capacity from a generic online chart.

Check daytime consumption

Appliances used while the sun is available can influence how you use solar generation. Your installer can explain expected self-consumption and grid interaction for your connection.

Measure usable roof space

Water tanks, shade, parapet walls and access paths reduce usable area. A site survey also confirms panel orientation and structural feasibility.

Use estimates carefully

Generation depends on location, weather, shading and system design. Use a calculator for a preliminary estimate, then validate it with a professional proposal.

Use the Solar Calculator Explore residential solar

Use consumption and site conditions together

kW is power or capacity; kWh is energy used or generated over time. Review actual consumption, daytime use, planned loads, roof shading and connection details before selecting a system.

A final proposal should state the layout, module and inverter ratings, generation assumptions and any backup design. Calculator-style estimates are not approval or engineering documents.

Discuss your requirement

Clear answers

Frequently asked questions

What is the difference between kW and kWh?

kW measures power or system capacity; kWh measures energy over time. A solar array's kW rating is not its guaranteed daily energy output.

Can my electricity bill determine the exact solar size?

Bills help, especially consumption in kWh, but roof feasibility, daytime loads, connection details and future demand must also be assessed.

Is 3kW enough for my home?

It depends on energy use and when appliances run. A site and consumption assessment is needed before deciding whether 3kW is suitable.

When should I consider a 5kW system?

Consider 5kW when consumption, roof layout and connection feasibility support it. Do not select the system solely because a neighbour has one.

Is a 10kW system always better than 5kW?

No. Oversizing can increase cost without matching use or approval constraints. Compare the design against actual consumption and site conditions.

How does shading affect capacity selection?

Shading reduces available generation and can affect string design. Survey trees, nearby buildings, parapets and rooftop equipment across the day.

How do I estimate the module count?

Divide the proposed DC capacity in watts by the selected module rating. Final quantities depend on inverter compatibility and the approved layout.

Can I estimate generation using a fixed national average?

An average can be only an initial assumption. Site irradiance, orientation, shading and losses need to be considered for a project estimate.

Should I include future appliances?

Yes, share planned loads such as air conditioning or EV charging. Future demand should be considered without assuming unlimited roof or connection capacity.

Does inverter kW always equal module kWp?

Not necessarily. The DC array and AC inverter ratings are different design values. Their ratio must remain within the model's permitted limits.

Is the website calculator a final engineering design?

No. The calculator uses your electricity use and editable generation assumptions to show a planning scenario. Roof feasibility, connection limits, shading and equipment compatibility still need a site-specific design.

What should I bring to a capacity consultation?

Bring recent electricity bills, roof details, electrical phase, sanctioned load and an appliance or backup-load list.